Abstract
The article describes the results of experiments which was intended to compare the results of turning and traverse grinding of internal cylindrical surfaces of rings made of bearing steel (100Cr6) in hardened state (62±2 HRC). During experimental investigations particular attention has been paid to the machining performance and roughness of the machined surface. The results of research presented in this article confirm the advantage of the turning process over traverse grinding using grinding wheels with zone-diversified structure.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
