Comparation between Laser Surface Nitriding and Nitrogen Plasma Immersion Ion Implantation (N-PIII) on Creep Behavior of Ti-6Al-4V Alloy

Abstract

Titanium alloys are widely used in machine building, aircraft manufacturing, medicine, motors, chemistry, and biomedicine due to their high strength-to-weight ratio, elasticity, corrosion resistance, and biocompatibility. In particular, Ti-6Al-4V containing (α + β) structure plays a very important role in aerospace industry in the manufacturing of components such as disks and blades for aircrafts turbines and structural forgings. However, one of the major factors limiting the life of titanium alloys in service is their degradation due to gaseous environments, in particular, to environments containing oxygen at elevated temperatures during long-term use. The sensitivity of titanium alloys to high-temperature exposure is a well-known phenomenon. When titanium alloys are heated to temperatures above approximately 800oC, oxygen, hydrogen and nitrogen can penetrate into them. The penetration of these elements increases hardness and brittleness while decreasing the toughness of the alloy. Laser surface nitriding is a technique used to modify the near-surface microstructure and/or composition by melting the surface using a high-power laser beam with reactive gas as a shrouding environment, forming a nitride layer on the surface of Ti–6Al–4V to improve the alloy’s tribological and mechanical properties. The results of laser gas nitriding of Ti–6Al–4V showed a significant increase of microhardness and enhanced erosion resistance significantly compared with untreated Ti–6Al–4V, since the nitride layer acts as a diffusion barrier for inward oxygen diffusion into the alloy, reducing the contribution of oxygen dissolution in the substrate to the total mass gain. Other important technique that was developed for the beneficial modification of surface sensitive properties is Nitrogen Plasma Immersion Ion Implantation N-PIII. A sample is immersed in plasma and subjected to negative high-voltage pulses. In the electrical field, the ions are accelerated to high energies and incorporated into the sample. Enhancing of the hardness and wear process of the materials due to the N-enriched layer caused by diffusion of N in the sample at PIII process can be expected. Both techniques provide an improvement in the creep resistance. The objective of this work was evaluating the creep resistance of the Ti-6Al-4V alloy with superficial treatments of laser nitriding and Nitrogen Plasma Immersion Ion Implantation N-PIII in creep test of Ti-6Al-4V alloy. It was used Ti-6Al-4V alloy as cylindrical bars under forged and annealing of 190 oC by 6 hours condition and cooled by air. The Ti-6Al-4V alloy after the superficial treatment of laser nitriding and N-PIII was submitted to creep tests at 600 oC in the stress of 250 MPa and 319 MPa, under constant load mode. The creep parameters are determined and a comparative analysis is established with the results gotten from the alloy with both treatments. The laser nitrided has showed an improved creep behavior compared with the same alloy with N-PIII coating, with a reduction in the creep rate and increasing the creep lifetime.