Abstract
This article proposes a compact coplanar waveguide (CPW) antenna with a semicircular patch and patch arm above the feed line. The method used in this antenna research is experimental, with antenna parameter optimization, fabrication, and measurement steps. The antenna was 40 mm × 46 mm × 0.8 mm and was printed on an FR4 substrate. Antenna optimization was carried out with CST Studio Suite to obtain optimal results. Based on return loss measurement results, the proposed antenna has an operational frequency of 2 GHz–7 GHz. The antenna arm has a significant effect on the operational frequency of the antenna, as proven by a parameter study of the antenna arm. Parametric studies were carried out on the antenna by investigating the influence of geometric parameters on the frequency characteristics. Optimization results were printed then measured by a Vector Network Analyzer (VNA) and a spectrum analyzer. The fabricated CPW antenna has a wider operating frequency than the simulation. An omnidirectional radiation pattern was observed at 2 GHz–4 GHz. The antenna has been used as a transmitter and receiver at 2.4 GHz, 3 GHz, and 4 GHz. The antenna is able to receive the signal emitted from the signal generator.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
