Compact and efficient O-band bismuth-doped phosphosilicate fiber amplifier for fiber-optic communications

Abstract

During last decades there has been considerable interest in developing a fiber amplifier for the 1.3-upmu m spectral region that is comparable in performance to the Er-doped fiber amplifier operating near 1.55 upmu m. It is due to the fact that most of the existing fiber-optic communication systems that dominate terrestrial networks could be used for the data transmission in O-band (1260–1360 nm), where dispersion compensation is not required, providing a low-cost increase of the capacity. In this regard, significant efforts of the research laboratories were initially directed towards the study of the praseodymium-doped fluoride fiber amplifier having high gain and output powers at the desired wavelengths. However, despite the fact that this type of amplifiers had rapidly appeared as a commercial amplifier prototype it did not receive widespread demand in the telecom industry because of its low efficiency. It stimulated the search of novel optical materials for this purpose. About 10 years ago, a new type of bismuth-doped active fibers was developed, which turned out to be a promising medium for amplification at 1.3 upmu m. Here, we report on the development of a compact and efficient 20-dB (achieved for signal powers between -40 and -10 dBm) bismuth-doped fiber amplifier for a wavelength region of 1300–1350 nm in the forward, backward and bi-directional configurations, which can be pumped by a commercially available laser diode at 1230 nm with an output power of 250 mW. The compactness of the tested amplifier was provided by using a depressed cladding active fiber with low bending loss, which was coiled on a reel with a radius of 1.5 cm. We studied the gain and noise figure characteristics at different pump and signal powers. A record gain coefficient of 0.18 dB/mW (at the pump-to-signal power conversion efficiency of above 27%) has been achieved.