Combustion of ammonium perchlorate fo near adiabatic condition at high pressures and elevated Initial temperature

Abstract

AbstractThis paper addresses the combustion of ammonium perchlorate (AP) near adiabatic conditions at high pressures and higher initial temperatures. The AP pellets were coated with a thin layer of silica grease to simulate the near adiabatic condition. The experiments were performed at initial temperatures of 30 and 70 °C in the pressure range of 2.5–30 MPa for coated and bare pellets. The bare pellets were found to exhibit mesa burning as reported in the literature. However, the coated pellets did not exhibit mesa burning. The burn rates of coated AP pellets increased linearly for the entire pressure range of 2.5–30 MPa with 0.64 pressure index. Further, the experiments were carried out for the first time at an initial temperature of 90 °C for 14–30 MPa pressure range, wherein, AP combustion did not display any characteristics of mesa burning (pressure index of 0.33). The surface morphology of quenched samples of both bare and coated pellets of AP were studied, by quenching (rapid depressurization technique) pellets at 6, 12, and 18 MPa pressures. The surface structure of quenched samples for near adiabatic conditions was similar for all three pressures. However, for bare pellets the changes in surface structure were observed with change in pressure, similar to the literature. Mesa burning was found to be an effect of convective heat loss from the periphery of the pellets and it was not observed when heat loss was reduced or initial temperature was higher than the critical initial temperature.