Abstract
In this work, combining ferrate (Fe(VI)) with thiosulfate (TS) to degrade chloramphenicol (CAP) was systematically investigated. A series of operational parameters were discussed, including Fe(VI) concentration, TS concentration, pH, molar ratio of TS/Fe(VI), some anions and humic acid. The degradation efficiency of CAP at an initial concentration of 31 μM reached 32 % and 51 % within 120 min and 420 min with single Fe(VI) system, respectively. In comparison, the removal efficiency of CAP reached 69 % under molar ratio of TS/Fe(VI) of 1:8 within 120 min in Fe(VI)/TS system. Additionally, the Fe(VI)/TS system showed higher removal efficiency during the pH ranging 5–9. HCO3- had dual effects and PO43- had obvious inhibitory effect, while Cl-, NO3- and HA had no remarkable effects on CAP degradation. The radicals scavenging experiments and electron spin resonance (ESR) experiments demonstrated both sulfate radical and hydroxyl radical were produced in Fe(VI)/TS system, but sulfate radical was the primary active species besides Fe(IV) and Fe(V). Subsequently, eight intermediates were detected by LC–MS/MS and three possible degradation pathways of CAP were proposed. Finally, the toxicity of the by-products was evaluated through the Escherichia coli (E. coli) toxicity test.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.