Abstract
The accuracy and execution speed of a force controlled contour following task is limited if the shape of the workpiece is unknown. This is even more true when the workpiece contour contains corners. This paper shows how a combined vision/force control approach at corners in planar contour following results in a more accurate and faster executed task. The vision system is used to measure on-line the contour and to watch out for corners. The edge is correctly located by incorporating the compliance of the tool/camera set-up in the contour measurement. A simple corner detection algorithm is presented. Once a corner is detected, the finite state controller is activated to take the corner in the best conditions. Experimental results are presented to validate the approach.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.