Combined effect of wood moisture content, drill bit rotational speed and feed rate on drilling resistance measurements in Norway spruce (Picea abies (L.) Karst.)

Abstract

ABSTRACT An IML-RESI PD 400 drilling tool and a standard spade drill bit (IML System GmbH, Wiesloch, Germany) were used to study the combined effect of wood moisture content (MC), drill bit rotational speed and feed rate on drilling resistance (DR) and feeding force (FF). Tests were made with Norway spruce (Picea abies (L.) Karst.) conditioned in a normal climate (20°C/65% RH), at 20°C/95% RH, vacuum-pressure impregnated in water, and oven-dried. Rotational speeds and feed rates had an impact on feed rate per cutting edge for the major cutting edge of the drill bit which was used for correlation with DR and FF for various MC. Impact of MC on DR and FF depended on rotational speeds and feed rates of the drill bit. For feed rates per cutting edge less than 0.09 mm, DR was higher for water saturated (WS) specimens. Negligible differences between DR for various MC were found for feed rates per cutting edge between 0.09 and 0.15 mm. DR was higher at low MC for feed rates per cutting edge which were higher than 0.15 mm. FF extremely increased in conditioned (20°C/95% RH) and WS specimens at feed rates per cutting edge less than 0.1 mm.