Combined corrosion and inclination effects on pullout behavior of various steel fibers under wet-dry cycle deterioration

Abstract

The interfacial bond behavior of corroded fibers in cracked steel fiber reinforced concrete (SFRC) is critical for understanding its structural deterioration performance, while available research focused on aligned straight or hooked-end fibers. This study investigated the combined effects of corrosion and inclination on the pullout performance of various steel fibers bridging artificial cracks exposed to wet-dry cycles of chlorides. Three deformed steel fibers, i.e., hooked-end (H), crimped (C), and milled-cut (M) fibers, with three angles of 0°, 30°, and 45° were examined under both uncorroded and corroded conditions. After corrosion, the average bond strength of H fibers was enhanced due to increased roughness and compact rust layer if the high inclination-induced fracture was avoided, while that of C and M fibers was decreased at various angles because of loose and porous rusts. The highest bond strengths of corroded H, C, and M fibers were discovered at 30°, 30°, and 0°, as a result of the combined mechanisms of snubbing effect, matrix spalling, or corrosion-induced fracture. The ultimate displacement of all fibers increased with angles due to increased matrix spalling area and fiber plastic deformation. The inclination effect of corroded fibers was more significant on energy absorption capacity than average bond strength, regardless of fiber type. A degradation model that describes the snubbing and matrix spalling effects, as well as the corrosion-induced deterioration and fracture was developed, based on which the critical inclination angle was found to decrease with increasing embedded length and decreasing tensile strength.