Abstract

During leather processing in tanneries, considerable amount of wastes with organic and inorganic pollutants are generated. For removal of these pollutants and recovery of water, biological treatment methods and reverse osmosis (RO) based membrane technologies are adopted. While recovering water from treated tannery effluent using RO membranes, presence of residual organics, dye molecules, and other impurities in the effluent have been reported as the major drawback which leads to membrane fouling and failure. In this study, an attempt was made to improve the quality of the treated tannery effluent by subjecting the secondary treated tannery effluent by ozonation alone and ozonation of primary and secondary treated tannery effluent followed by aerobic biological Sequential Batch Reactor (SBR). Maximum color reduction of 98% at pH value of 12 with ozonation alone was observed for secondary treated tannery effluent. Ozonation of secondary treated tannery effluent followed by further biological treatment in aerobic SBR increased the chemical oxygen demand (COD) removal rate and resulted in COD values less than 300 mg/L. In case of primary treated tannery effluent, maximum COD reduction of 64% was achieved in SBR.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.