Abstract
In this work, we have prepared BiOI/CNT composites by hydrothermal method and studied the impact of CNT and hydrothermal treatment conditions (temperature and time) simultaneously on phenomena such as crystallization. The samples were studied using X-ray Diffraction (XRD), nitrogen sorption (Brunauer–Emmett–Teller (BET) specific surface areas), Scanning Electron Microscopy assisted with Energy Dispersive X-Ray spectroscopy (SEM-EDX), High Resolution Transmission Electron Microscopy (HRTEM), UV–vis Diffuse Reflectance spectroscopy (DRS), Raman spectroscopy and photoluminescence spectroscopy (PL). The different heat treatments applied and varied amount of CNT was found to have a profound effect on the structural, morphological, compositional and optical properties of the prepared composites. The distinguishable changes in the above-mentioned properties were clearly visible for the samples prepared at higher temperature and longer duration (150 °C, 6.30 h). Surprisingly, the presence of other phases of BiOI, such as Bi7O9I3, Bi4O5I2, Bi5O7I, also co-existed at the same time, although in low amount. Finally, for the study, the photocatalytic efficiency of the prepared samples was tested for phenol and RhB, as model pollutants, under visible light irradiation for 240 min and 120 min, respectively. The results revealed that the composites prepared at higher temperature with longer duration showed superior performance for the photodegradation of phenol and RhB. Additionally, the composites performed better than their respective reference samples in each case. Interestingly, the introduction of CNT promoted the crystallinity in the composites and promising results for the removal of phenol and RhB were achieved by the use of low power ordinary visible lamps.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have