Abstract
A design diagram of comb formation roller in resilient stems is given. Comb-forming roller consists of support and small discs, as well as elastic rods. Elastic rods are installed along the perimeter of the diameter of the disks through their holes. Analytical dependences and mathematical models are obtained for determining the distance between disks, the diameter of disks, the diameter, length and number of elastic rods. One-factor experiments were carried out to substantiate the diameter of the disks and the number of rods. It was found that with the length of the elastic rods of the comb-forming roller 65-75 cm, the diameters of large, medium and small discs, respectively, at least 600mm, 550 mm and 200 mm, the angle of sharpening of the discs within 55-650, the issue of stems within 64 - 69 trimming and diameter bars 3 mm, intensive defeat of chunk and high- quality creation of ridges is ensured.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
