Abstract

Understanding the stability and aggregation of nanoparticles in aqueous milieu is critical for assessing their behavior in the natural and engineered environmental systems and establishing their threat to human and ecosystems health. In this study, the colloidal stability and aggregation kinetics of nanocrystal quantum dots (QDs) —CdSe/ZnS QDs—were thoroughly explored under a wide range of aqueous environmental conditions. The z-average hydrodynamic diameters (z-avg. HDs) and zeta potential (ξ potential) of CdSe/ZnS QDs were measured in monovalent electrolyte (NaCl) and divalent electrolyte (CaCl2) solutions in both the absence and presence of natural organic matter (NOM)—Suwannee River natural organic matter, SRNOM to assess the dynamic growth of these nanoaggregate-QD-complexes, and the evaluation of their colloidal stability. Results show that CaCl2 was more effective to destabilize the QDs compared to NaCl at similar concentrations. An increase in NaCl concentration from 0.01 to 3.5 M increased the z-avg. HD of QD aggregates from 61.4 nm to 107.2 nm. The aggregation rates of QDs increased from 0.007 to 0.042 nm·s−1 with an increase in ionic strength from 0.5 to 3.5 M NaCl solutions, respectively. In the presence of Na+ cations, the aggregation of QDs was limited as steric forces generated by the original surface coating of QDs prevailed. In the presence of CaCl2, the aggregation of QDs was observed at a low concentration of CaCl2 (0.0001 M) with a z-avg. HD of 74.2 nm that significantly increased when the CaCl2 was higher than 0.002 M. Larger sizes of QD aggregates were observed at each level of CaCl2 concentration in suspensions of 0.002–0.1 M, as the z-avg. HDs of QDs increased from 125.1 to 560.4 nm, respectively. In the case of CaCl2, an increase in aggregation rates occurred from 0.035 to 0.865 nm·s−1 with an increase in ionic strength from 0.0001 M to 0.004 M, respectively. With Ca2+ cations, the aggregation of QDs was enhanced due to the bridging effects from the formation of complexes between Ca2+ cations in solution and the carboxyl group located on the surface coating of QDs. In the presence of SRNOM, the aggregation of QDs was enhanced in both monovalent and divalent electrolyte solutions. The degree of aggregation formation between QDs through cation-NOM bridges was superior for Ca2+ cations compared to Na+ cations. The presence of SRNOM resulted in a small increase in the size of the QD aggregates for each of NaCl concentrations tested (i.e., 0.01 to 3.5 M, except 0.1 M), and induced a monodispersed and narrower size distribution of QDs suspended in the monovalent electrolyte NaCl concentrations. In the presence of SRNOM, the aggregation rates of QDs increased from 0.01 to 0.024 nm 1 with the increase of NaCl concentrations from 0.01 to 2 M, respectively. The presence of SRNOM in QDs suspended in divalent electrolyte CaCl2 solutions enhanced the aggregation of QDs, resulting in the increase of z-avg. HDs of QDs by approximately 19.3%, 42.1%, 13.8%, 1.5%, and 24.8%, at CaCl2 concentrations of 0.002, 0.003, 0.005, 0.01, and 0.1 M, respectively. In the case of CaCl2, an increase in aggregation rates occurred from 0.035 to 0.865 nm·s−1 with an increase in ionic strength from 0.0001 to 0.004 M, respectively. Our findings demonstrated the colloidal stability of QDs and cations-NOM-QD nanoparticle complexes under a broad spectrum of conditions encountered in the natural and engineered environment, indicating and the potential risks from these nanoparticles in terms of human and ecosystem health.

Highlights

  • Among the various types of nanoparticles, quantum dots (QDs), which are semiconductor nanoscale crystals, encompass a wide range of areas of application owing to their optical and electronic properties [1]

  • HD of QDs dispersed in d­ iH2O at the neutral pH of 7 was measured by dynamic light scattering (DLS) prior to investigating the effect of the electrolyte type and concentration, in both the absence and presence of SRNOM on their aggregation kinetics

  • The surface charge measurements indicated that the QDs with a zinc sulfide (ZnS) shell and octylamineadjusted poly(acrylic acid) (OA-PAA) surface modification used in this study were negatively charged in a ­diH2O suspension at a pH of 7

Read more

Summary

Introduction

Among the various types of nanoparticles, quantum dots (QDs), which are semiconductor nanoscale crystals, encompass a wide range of areas of application owing to their optical and electronic properties [1]. Environmental factors influencing the fate and transport characteristics of nanoparticles, including QDs, include: water chemistry (e.g., pH, electrolyte type, ionic strength, organic matter, and surfactant) [39, 42–48]; natural and engineered porous media materials (e.g., sand and soil) [47, 49]; degree of saturation (e.g., unsaturated and saturated) [45, 50, 51]; hydraulic properties of porous media materials (e.g., flow velocity and hydraulic conductivity); fluid flow in porous media materials (e.g., saturated flow, unsaturated flow, and preferential flow phenomena such as unstable fingered flow) [42, 50, 52, 53]; and porous media geometrical characteristics (e.g., grain size distribution and grain shape irregularity) [45]

Objectives
Methods
Results
Discussion
Conclusion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.