Coherence- and Amplitude-Based Analysis of Seismogenic Damage in Bam, Iran, Using ENVISAT ASAR Data

Abstract

The sensitivity of synthetic aperture radar (SAR) and interferometric SAR (InSAR) to surface properties, especially changes in height and roughness, combined with an all-weather capability, makes radar remote sensing a potential tool for mapping urban caused by earthquakes. With InSAR, surface displacement has been mapped successfully and in detail, but for urban-damage mapping, results have so far been less conclusive. ENVISAT Advanced SAR images of Bam, Iran, that were acquired before and after the 2003 earthquake were used. Between preseismic and coseismic image pairs, coherence decreased with increasing levels. However, contrary to previous studies, earthquake caused both increases and decreases in amplitude. Therefore, its absolute value, which correlated with level, was used. Individually, coherence difference led to better results than absolute amplitude change, although still with limited accuracy. The combination of both resulted in an overall accuracy of 52%. Since vegetation causes decorrelation, a predisaster Advanced Spaceborne Thermal Emission and Reflection Radiometer image was used to mask out vegetated areas, which improved the accuracy by 4%. The ground-truth map showed levels per district instead of per pixel. Therefore, the ratio of pixels classified as damage and nondamage was calculated for each class of the map, and a clear relation was found. This shows that the aggregation level of the map partly explains the low-accuracy figures of the pixel-based evaluation. Although improvement was made, InSAR techniques for urban-damage mapping do not yet provide the accuracy levels needed for disaster mitigation. However, substantial improvements can be expected from instruments with higher spatial resolution, such as the recently launched Phased Array type L-band SAR and Terra SAR-X