Abstract
Film cooling holes (FCHs) of nickel-based single crystal turbine blades were drilled by 532 nm Nd:YVO4 nanosecond laser in coaxial waterjet-assisted environment. Microstructure of the side wall of the FCHs was mainly investigated by means of transmission electron microscopy. The average thickness of heat affected zone (HAZ) around FCHs decreases with increasing of water flow rate. The main phase within HAZ evolves from β-NiAl to β-NiAl + γ-Ni with the increase in the water flow rate. Some γ-Ni particles in the HAZ twined along (111) plane. A small portion of the FCHs are free of HAZ when drilled by coaxial waterjet-assisted laser drilling at a laminar water flow rate ≥3.1 m/s. There are no processing-induced defects including HAZ, microcrack, and phase transformation around the FCHs when drilled at the water flow rate ≥5.1 m/s. The FCHs with high surface quality can be drilled by the coaxial waterjet-assisted laser drilling. Finally, effects of fluid water on drilling quality of the FCHs were discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Machine Tools and Manufacture
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
