Abstract
Coarse control and fine control of the resonant frequency of a loop-gap resonator (LGR) operating at an electron paramagnetic resonance (EPR) frequency of ca. 650 MHz were achieved using a single-turn coil with a varactor diode attached (a frequency shift coil). When the distance between the LGR and the frequency shift coil was changed from 15 to 10 mm under the condition of constant voltage to the varactor diode (0 V), a shift of the resonant frequency of the LGR of ca. 20 MHz was observed (coarse frequency control). When the voltage applied to the varactor diode was changed from 0 to 15 V at the same distance between the LGR and the frequency shift coil (10 mm), a shift of the resonant frequency of the LGR of ca. 200 kHz was observed (fine frequency control). There were no significant changes in sensitivity of EPR measurements of a phantom (comprised of agar with a nitroxide radical and physiological saline solution) without and with the frequency shift coil. The EPR sensitivity did not change discernibly when the resonant frequency was shifted by the frequency shift coil. Furthermore, radio-frequency phase adjustment for homodyne detection could be performed by using the frequency shift coil without applying frequency modulation to the carrier wave.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.