Abstract
The results of a laboratory testing program carried out to investigate the effect of coarse aggregate types on the elastic modulus of typical pavement concretes are presented. The elastic modulus was determined in both flexure and compression using static and dynamic means. Three different mixes, made using three different aggregates, were compared. The water-cement ratio was kept at 0.53 throughout the test program. The results showed that within the tested range, the aggregate type significantly affected the studied properties of concrete. Calera aggregate (a dense limestone) with its rough-textured surface and angular shape produced a concrete with higher strength and stiffness than those of concretes made with Brooksville aggregate (a porous limestone) and river gravel. In addition, the measured dynamic modulus in compression was significantly different from that in flexure. Also, in flexure, the dynamic modulus was higher than the static modulus by an average of 23 percent, whereas in compression, th...
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Transportation Research Record: Journal of the Transportation Research Board
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
