CO2 flooding strategy to enhance heavy oil recovery

Abstract

Abstract CO2 flooding is one of the most promising techniques to enhance both light and heavy oil recovery. In light oil recovery, the production pressure in CO2 flooding in general keeps constant in order to maintain the miscibility of injected CO2 and crude oil; while in heavy oil recovery, a depleting pressure scheme may be able to induce foamy oil flow, thus the oil recovery could be further enhanced. In this study, different pressure control schemes were tested by 1-D core-flooding experiments to obtain an optimized one. Numerical simulations were conducted to history match all experimental data to understand the mechanisms and characteristics of different CO2 flooding strategies. For the core-flooding experiments, 1500 mD sandstone cores, formation brine and a heavy oil sample with a viscosity of about 869.3 cp at reservoir condition (55 °C and 11 MPa) were used. Before each CO2 flooding test, early stage water-flooding was conducted until the water cut reached 90%. Different CO2 injection rates and production pressure control strategies were tested through core-flooding experiments. Experimental results indicated that a slower CO2 injection rate (2 ml/min) led to a higher recovery factor from 31.1% to 36.7%, compared with a high CO2 injection rate of 7 ml/min; for the effects of different production strategies, a constant production pressure at the production port yielded a recovery factor of 31.1%; while a pressure depletion with 47.2 kPa/min at the production port yielded 7% more oil recovery; and the best pressure control scheme in which the production pressure keeping constant during CO2 injection period, then depleting the model pressure with the injector shut-in yielded a recovery factor of 42.5% of the initial OOIP. For the numerical simulations study, the same oil relative permeability curve was applied to match the experimental results to all tests. Different gas relative permeability curves were obtained when the production pressure schemes are different. A much lower gas relative permeability curve and a higher critical gas saturation were achieved in the best pressure control scheme case compared to other cases. The lower gas relative permeability curve indicates that foamy oil was formed in the pressure depletion processes. Through this study, it is suggested that the pressure control scheme can be optimized in order to maximize the CO2 injection performance for enhanced heavy oil recovery.