CO interaction with Au atoms adsorbed on terrace, edge and corner sites of the MgO(1 0 0) surface. Electronic structure and vibrational analysis from DFT

Abstract

The interaction of CO with Au atoms adsorbed on terrace and low-coordinates sites (edge and corner) of the MgO(1 0 0) surface was studied using the density functional theory (DFT) in combination with embedded cluster models. Surface anionic (O 2−) and neutral oxygen vacancy (F s) sites were considered. In all the cases, the CO stretching frequencies are shifted with respect to free CO with values between −232 and −358 cm −1. In particular, the values for Au on F s at edge and corner are shifted to higher stretching frequencies by 100 and 59 cm −1, respectively, with respect to the value on a perfect MgO(1 0 0) surface. This result is in agreement with recent scanning tunneling microscopy and infrared spectroscopy experiments where a corresponding shift of 70 cm −1 was observed by comparing the measurements on perfect and O-deficient MgO(1 0 0) surfaces. However, these results are different than expected because Au atoms on F s centers are negatively charged and, therefore, according to the generally accepted scheme the CO frequency should be red-shifted with respect to the adsorption on anionic five-coordinated site where the Au atom is essentially neutral. The following picture emerges from the present results: the single occupied HOMO(α) of Au atom on F s at low-coordinated sites consists in two lobes extended sideward the Au atom. For symmetry reasons, this MO overlaps efficiently with the 2π ∗ MO of CO. This bonding contribution to the Au–CO link is counteracted by a Pauli repulsion between the 5σ MO of CO and more internal orbitals (the HOMO-1(α) and the HOMO(β)) centered on Au. In consequence, CO is forced to vibrate against a region with a high electron density. This is the so-called “wall effect” which by itself contributes to higher CO frequency values.