Co‐injection molding of PVC with other thermoplastics: Processing, properties, and applications

Abstract

AbstractRigid poly(vinyl chloride) (PVC) was co‐injected with glass‐fiber‐reinforced PVC (GFR‐PVC), polypropylene (PP), acrylonitrile‐butadiene‐styrene copolymer (ABS), and polycarbonate (PC) by using the Mono‐sandwich co‐injection process. Up to three through‐thickness skin‐core morphologies were observed along the length of the sample. Near the gate, the core was always a single, continuous layer. In some cases, the core diverged into multiple or discontinuous layers. Farther from the gate, flow of the core ceased, leaving a skin‐only region. The skin and core layers were more uniformly distributed through the test plaque when injection speed was low. Adhesion between PVC and PP was poor. Skin and core layers delaminated, and mechanical properties were poor. The PVC adhered well to GFR‐PVC, ABS, and PC. No layer delamination occurred, and mechanical properties were intermediate between those of the skin and core components alone. Dropped dart impact energy was controlled more by the skin layer than the core. In rigid PVC/GFR‐PVC co‐injected samples, impact energy was 2.5 times greater when GFR‐PVC was the core than when GFR‐PVC was the skin.