Abstract
Unloaded WO3 and 0.25-1.0 wt% Pt-loaded WO3 nanoparticles were synthesized by hydrothermal method using sodium tungstate dihydrate and sodium chloride as precursors in the acidic condition and further by the impregnation method using platinum acetylacetonate. Pt-loaded WO3 films on Al2O3 substrate interdigitated with Au electrodes were prepared by spin-coating technique. The temperature has an obvious influence on the response of sensors to CO gas. In order to determine the optimal operating temperatures, the response of WO3 sensors with different Pt loading concentrations towards 50-2000 ppm of CO in air was tested as a function of operating temperature of 150-350 degrees C. It was found that 1.0 wt% Pt-loaded WO3 sensing film showed the highest response of - 469 at 2000 ppm CO (250 degrees C). Therefore an optimal operating temperature of 250 degrees C was chosen for CO detection.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
