CO and HCHO Sensing by Single Au Atom-Decorated WS2 Monolayer for Diagnosis of Thermal Aging Faults in the Dry-Type Reactor: A First-Principles Study.

Abstract

CO and HCHO are the main pyrolysis gases in long-term running dry-type reactors, and thus the diagnosis of thermal insulation faults inside such devices can be realized by sensing these gases. In this paper, a single Au atom-decorated WS2 (Au-WS2) monolayer is proposed as an original sensing material for CO or HCHO detection to evaluate the operation status of dry-type reactors. It was found that the Au atom prefers to be adsorbed at the top of the S atom of the pristine WS2 monolayer, wherein the binding force is calculated as -3.12 eV. The Au-WS2 monolayer behaves by chemisorption upon the introduction of CO and HCHO molecules, with the adsorption energies of -0.82 and -1.01 eV, respectively. The charge density difference was used to analyze the charge-transfer and bonding behaviors in the gas adsorptions, and the analysis of density of state as well as band structure indicate gas-sensing mechanisms. As calculated, the sensing responses of the Au-WS2 monolayer upon CO and HCHO molecule introduction were 58.7% and -74.4%, with recovery times of 0.01 s and 11.86 s, respectively. These findings reveal the favorable potential of the Au-WS2 monolayer to be a reusable and room-temperature sensing candidate for CO and HCHO detections. Moreover, the work function of the Au-WS2 monolayer was decreased by 13.0% after the adsorption of CO molecules, while it increased by 1.2% after the adsorption of HCHO molecules, which implies its possibility to be a work-function-based gas sensor for CO detection. This theoretical report paves the way for further investigations into WS2-based gas sensors in some other fields, and it is our hope that our findings can stimulate more reports on novel gas-sensing materials for application in evaluating the operation conditions of dry-type reactors.