Abstract
Turbine alarm systems can give useful information to remote technicians on the cause of a fault or stoppage. However, alarms are generally generated at much too high a rate to gain meaningful insight from on their own, so generally require extensive domain knowledge to interpret. By grouping together commonly occurring alarm sequences, the burden of analysis can be reduced. Instead of analysing many individual alarms that occur during a stoppage, the stoppage can be linked to a commonly occurring sequence of alarms. Hence, maintenance technicians can be given information about the shared characteristics or root causes of stoppages where that particular alarm sequence appeared in the past. This research presents a methodology to identify relevant alarms from specific turbine assemblies and group together similar alarm sequences as they appear during stoppages. Batches of sequences associated with 456 different stoppages are created, and features are extracted from these batches representing the order the alarms appeared in. The batches are grouped together using clustering techniques, and evaluated using silhouette analysis and manual inspection. Results show that almost half of all stoppages can be attributed to one of 15 different clusters of alarm sequences.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.