Closed Chain Simulations of a Cast Aluminium Component - Incorporating Casting Process Simulation and Local Material Characterization into Stress-strain Simulations

Abstract

The coupling between simulations of solidification, microstructure and local mechanical behaviour and simulation of stress-strain behaviour is studied by applying a recently developed simulation strategy to a high pressure die cast aluminium component. In the simulation strategy, named a closed chain of simulations for cast components, the mechanical behaviour throughout the component is determined locally by a casting process simulation. The entire casting process, including mould filling and solidification, is simulated to predict the formation of microstructure and residual stresses throughout the component, and material characterization models are applied to relate microstructural features to local elastic and plastic mechanical material behaviour. The local material behaviour is incorporated into a finite element method (FEM) stress-strain simulation of a realistic load case of the component in service.In the current contribution the influences of local variations in mechanical behaviour and residual stresses on the component behaviour are investigated. The simulation results for local microstructure and mechanical behaviour are compared to experimental results, and the predicted local mechanical behaviour is incorporated on an element level into the FEM simulation. The numerical effect of the variations in mechanical behaviour is quantified by comparing the results achieved using local behaviour and homogeneous behaviour. The influence of residual stresses predicted by the casting process simulation on the component behaviour is also studied.The casting process simulation is found to accurately predict the local variations in microstructure throughout the component, and the local variations in mechanical behaviour are well described. The numerical results show that casting process simulation and modelling of microstructure formation, material behaviour and residual stresses are important contributions to correctly predict the behaviour of a cast aluminium component in service. This motivates the use of the proposed simulation strategy, and show the importance of incorporating materials science and casting process simulations into structural analyses of cast components. It is discussed that integration of these areas, e.g. using the closed chain of simulations, is important in order to increase the accuracy of FEM simulations and the product development efficiency in the future.