Abstract
Traditionally, removable partial dentures (RPDs) have been made by using an elastic impression material and casting from a framework wax pattern on a refractory cast. In this short communication, the procedures for digitally fabricating removable partial dentures using an intraoral scanner (IOS) and additive manufacturing system (AM) are described. The adaptation accuracy of the RPD using IOS and AM techniques was evaluated subjectively as good or satisfactory.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.