Clearance Effects on the Onset of Instability in a Centrifugal Compressor

Abstract

This report intends to shed an insight into the effect of large relative tip clearances on the onset of instability in a highly loaded centrifugal compressor. Time-resolved pressure measurements have been performed along the casing of a scaled-up model of a small compressor for two clearances at a wide range of operating conditions. Based on these time-resolved measurements, the pressure distribution along the meridional length and the blade loading distribution are calculated for each operating condition. In addition, the phase locked pressure fluctuation and its deviation are computed. The results show the behavior of each subcomponent of the compressor at different flow conditions and explain the role of the relative tip clearance on the onset of instability. For high mass-flow rates, the steady pressure distribution along the casing reveals that the inducer acts as an accelerating nozzle. Pressure is only built up in the radial part due to the centrifugal forces and in the subsequent diffuser due to area change. For off-design conditions, incidence effects are seen in the blade loading distribution at the leading edge while the inducer is unloaded. A region of high pressure deviation originates at the leading edge of the main blade and convects downstream. This feature is interpreted as the trajectory of the leakage vortex. The trajectory of these vortices is strongly affected by the mass-flow coefficient. If the mass-flow rate is sufficiently small, the trajectory of the leakage vortex becomes perpendicular to the axis of rotation, the leakage vortex interacts with the adjacent blade, and inlet tip recirculation is triggered. If the flow rate is further reduced, the leakage vortex vanishes and rotating stall is initiated in the diffuser. For larger clearances, stronger vortices are formed, stall is triggered at higher flow rates, and the overall compressor performance deteriorates.