Abstract

ABSTRACT Ten samples of felsic plutonic rocks from the Eastern Segment of the Sveconorwegian Orogen in southern Sweden, previously dated by ID-TIMS on zircon, have been dated anew using SIMS spot analysis of individual zircon grains, leading to more reliable and in most cases also more precise revised magmatic crystallization ages. A gneissic monzonite within the Protogine Zone in Småland yields a revised U-Pb age of ca. 1725 Ma, four samples of orthogneiss from Skåne all yield revised ages between 1700 and 1690 Ma, while two samples of coarse-grained granitic gneiss in the same region yield ages between 1690 and 1680 Ma. These revised ages are between 15 and 250 m.y. older than previously obtained TIMS ages. Two samples of the Gumlösa-Glimåkra granite along the Protogine Zone in northern Skåne and one sample of related syenite yield ages around 1220 Ma, similar but more precise compared to the previous ages. The U-Pb zircon data have been complemented by Hf isotope analysis by LA-ICP-MS on the same grains, and previously obtained initial Sr and Nd whole-rock isotope data have been recalculated to the revised crystallization ages. The Sr isotope data scatter, while the revised initial εNd values fall between +1 and +2 for the older rocks, and close to 0 for the younger intrusives along the Protogine Zone. Initial εHf in magmatic undisturbed zircons shows relatively little spread within each sample, between 2 and 4 Epsilon units, disregarding a few outliers, with average values for the 1725 to 1680 Ma rocks between +3 and +5.5 and for the 1220 Ma rocks at ca. +1.5. Covariation between initial εNd and initial εHf in the older rocks suggests either mixing between two isotopically distinct magma sources or one magma source which was isotopically heterogeneous. The isotopic signatures of the 1220 Ma intrusive rocks along the Protogine Zone are indicative of juvenile mantle input to their magmas, rather than pure crustal melting.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call