Abstract

Methane hydrate films, each growing along a horizontal interface between the quiescent liquid‐water and methane‐gas phases, were observed through a low magnification microscope to reveal the morphology and advancing motion of the film front, and the linear film growth rate (advancing speed of the film front) at various degrees of system subcooling from the phase‐equilibrium temperature corresponding to the system pressure was quantitatively measured. At a lower subcooling (≈ 1.2 K), the film front was often covered by laterally aligned facets showing a regular roughness with sharp peaks and valleys and a non‐isotropic growth. As the subcooling increased, the film front tended to have an irregular, non‐faceted, smaller‐scale roughness and exhibited a smoother, isotropic growth. For such an isotropic, quasi‐steady film growth at subcoolings from ∼2.5 to ∼10 K, we collected the film‐growth rate data. The obtained data were compared to other relevant data or empirical correlations previously reported by different research groups. The consistency or inconsistency between the different data sources were examined in detail.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.