Classification of particles by centrifugal separator and analysis of the fluid behavior

Abstract

This study gives fundamental knowledge on the particle classification performance by centrifugal separator. It is found that the cut size of a centrifugal separator decreases as the rotational speed increases and the liquid flow rate decreases. Fitting our experimental results with the theory, they agree with each other at high flow rate. However, the difference between them generates at low flow rate. This is because dead spaces are generated in the centrifugal separator at the low flow rate. Also, the computer simulation of the fluid behavior in the centrifugal separator can find the decrease of the velocity near the wall under the low flow rate, which suggests the possibility of the formation of dead spaces in the separator.