Clamps and saddles – Part 2: Remarks on detailing and testing

Abstract

AbstractThe article presents the current status of the revision of EN 1993‐1‐11 with regard to the design of saddles and clamps for ropes or for parallel wire tension components for suspended structures. The focus here is on presenting a general approach for clamps. For saddles, emphasis is on types where the slip resistance is – in addition to the component from deviation forces – increased by clamping forces, although general aspects are also covered. This part 2 deals with the geometrical requirements for clamps and in particular saddles and with the associated verification of the transverse pressure. Finally, testing is briefly discussed, with the emphasis on linking the design and the confirmation of the assumptions made thereby with the tests.