Abstract

High loads of natural organic matter (NOM) in source waters increase levels of toxic disinfection byproducts (DBPs) during treatment, including trihalomethanes (THMs) and haloacetic acids (HAAs), which are formed when NOM is chlorinated. Rates of NOM loading and, by extension, DBP formation potential vary spatially and temporally, and depend on land use within the watersheds. While non-chemical disinfection is typically based on mercury UV lamps, LED-based disinfection systems are being considered as an energy efficient alternative, since they require a fraction of the energy used by mercury lamps. This study explores the efficacy of a novel water treatment process for bacterial removal and DBP management that uses conventional NOM removal processes, and LED-based UVC and chlorine as primary and secondary disinfectants, respectively. Samples were collected from urban, agricultural, and forested watersheds during the summer and fall of 2018. Results show that LED-UVC with secondary chlorination results in the removal of all bacteria while producing 25% of the THMs and HAAs formed through conventional treatment during summer sampling, regardless of the land use. However, increased lignin-based plant matter during fall from defoliation inhibited conventional NOM removal, increasing turbidity and reducing UV transmittance. Additionally, due to the high concentration of NOM, DBP formation exceeded MCLs during the fall season. Therefore, consideration needs to be given to not only alternative disinfection strategies, but also to more efficient NOM removal processes that will reduce byproduct formation during disinfection and increase UV transmittance.

Highlights

  • Global water resources are under severe stress from over-pumping and contamination, while climate change-induced extreme weather events and unpredictable weather patterns will further degrade the quality of existing water resources (Arnell, 1999)

  • The presence of disinfection byproducts (DBPs) is a major challenge in drinking water quality treatment, and as a result, water managers often face the challenge of eliminating harmful pathogens while managing DBP levels (Chowdhury et al, 2011)

  • The significance of using UVPD and UVPD with a granular activated carbon (GAC) filter may become more apparent in scenarios where concentrations of total organic carbon (TOC) and other DBP precursors are higher in the source water

Read more

Summary

Introduction

First discovered in 1974, the United States Environmental Protection Agency (UESPA, 2012) currently regulates four trihalomethanes (THM4) and five haloacetic acids (HAA5) at maximum contaminant levels (MCLs) of 80 and 60 g/l, respectively. Global water resources are under severe stress from over-pumping and contamination, while climate change-induced extreme weather events and unpredictable weather patterns will further degrade the quality of existing water resources (Arnell, 1999). First discovered in 1974, the United States Environmental Protection Agency currently regulates four trihalomethanes (THM4) and five haloacetic acids (HAA5) at maximum contaminant levels (MCLs) of 80 and 60 g/l, respectively (USEPA, 2018)

Objectives
Methods
Discussion
Conclusion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.