Abstract
Chitosan is a natural polymer that is very common in many applications. In addition, Nicotine is a natural dye. To prepared Chitosan Nicotine (CN) layer we mix (1: 1) ratios from the Chitosan doping with Nicotine dye. After that, it is used as an active layer in solar cells. The morphology of the surface for the prepared layer is studied by scanning electron microscopy technique (SEM). From this study, We found that the surface of Chitosan could be more regular when it dopant with Nicotine than being a lone. The optical properties of samples were studied from UV-Visible spectra at wavelengths 300-900 nm. The analysis of optical measurements data showed that the absorbance increased after mixing the Chitosan with Nicotine. The parameters of solar cell were calculated within the voltage range (1-12Volt) and noted that the Short Circuit Current (JSC =1.6x10-3) mA/cm2, Open Circuit Voltage (VOC =7x10-2) V, Fill Factor (FF=0.51), Series Resistance (RS= 60) Ω and Shunt Resistance (Rsh= 250) Ω.were noted.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: University of Aden Journal of Natural and Applied Sciences
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.