Abstract
Based on our recent work on the three-dimensional graphene fillers (3DGF) reinforced epoxy (EP) composite, here commercially available graphite platelets (GP) were incorporated together with 3DGF to modify EP in order to further improve the thermal conduction and wear resistance of the EP composites. Remarkably, only 0.14 vol% 3DGF was needed to enhance the thermal conduction of EP by 170%, in contrast with the fact that 37 times content of graphite fillers were required to achieve almost the same enhancement. Moreover, in the presence of both 5.38 vol% GP and 0.14 vol% 3DGF, the thermal conductivity of EP was further enhanced by 258%. Meanwhile, the tribological test results revealed the advantage of 3DGF over GP. The ternary EP composite modified with both 0.28 vol% of 3DGF and 5.38 vol% GP had much lower specific wear rate and coefficient of friction than those binary composites with either 3DGF or GP.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.