Chemiresistive sensor based on PMMA/rGO composite for detection ammonia

Abstract

Reduced graphene oxide (rGO) has been a promising material in sensing applications. However, rGO-based sensors have very high recovery time at room temperature (RT). Therefore, various materials combination needs to explored to address this issue. We have developed chemiresistive sensor based on a composite of Poly (methyl methacrylate) (PMMA) and rGO for detection of ammonia (NH3). To prepare more oxidized graphene oxide (GO), peroxidation of graphite oxide (PGO) was used from graphite by following Improved Hummer’s Method (IHM). Due to PGO, synthesized rGO was more conductive and high charge capacity. Synthesized PMMA/rGO composite was drop cast on fabricated interdigitated copper electrodes. Various characterization tools were used for materials confirmation. The chemiresistive sensor based on PMMA/rGO exhibited very good sensing behaviour towards NH3 analytes. The range of detection was 1 ppm to 10 ppm with very good reproducibility. It was far below the Occupational Safety and Health Administration Permissible Exposer Limit (OSHA PEL) of NH3. A chemiresistive sensor based on PMMA/rGO composite revealed better sensing results than a pristine rGO sensor. The response time and recovery time for rGO based sensor was 122s and 168s respectively at 2 ppm of NH3 whereas for PMMA/rGO based sensor it was 50s and 75s respectively. Moreover, the PMMA/rGO based sensor exhibited repeatability at 2 ppm for NH3 at RT. This type of PMMA/rGO sensor will be very much useful for the detection of hazardous gases in chemical laboratories and industrial areas.