Abstract

To satisfy the electrical and thermomechanical requirements for a continuous wave millimeter wave beam transmission, a window assembly using a large size synthesized diamond disk has been developed. Such window systems are needed as a vacuum barrier and tritium shielding in future electron cyclotron heating systems for fusion plasma heating and noninductive electron cyclotron current drive. The diamond used in this study was manufactured by chemical vapor deposition (CVD) and consists of a polycrystalline diamond disk 96 mm in diameter and 2.23 mm thick. The disk was built into an assembly in which two Inconel tubes were bonded on both sides of the plate to provide vacuum shielding and water cooling to the edge of the disk, leaving an effective window aperture of 83 mm. It will be shown that, as a result of the high thermal conductivity and low dielectric loss exhibited by this grade of CVD diamond, the temperature increase of the window due to the absorption of high-power millimeter wave radiation could be minimized by simple water edge cooling at room temperature. During transmission of a focused Gaussian beam of 170 GHz, 110 kW, 10 s, the temperature increase at the center of the window reached a steady state condition at a value of approximately 40 K, in good agreement with calculated values. Water-edge-cooled CVD diamond windows promise to provide a practical technical solution for the transmission of continuous millimeter wave transmission in excess of 1 MW.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.