Chemical Substitution Strategies for Tailoring P2- and O3-Type Layered Oxide Cathodes in Sodium-Ion Batteries

Abstract

Among cathodes for sodium-ion batteries (SIBs), layered transition metal oxides Na x MO2 (M = transition metal) are very promising due to their easy synthesis and high theoretical capacity.1,2 In this class, Ni/Mn/Fe-based layered oxides are attractive due to the high redox potential of Ni2+/ Ni4+ and Jahn Teller inactive centers (Ni2+, Fe3+,and Mn4+).3 However, complex phase transitions, Na+/vacancy ordering and transition-metal (TM) migration degrade their electrochemical performances.4 To address the issues, a widely studied cathode- P2-type Na0.67[Ni0.33Mn0.67]O2 is chosen and Li+ is substituted in the TM-layer to tailor a series of high Na-content cathodes. Among them, Na0.85[Li0.14Ni0.29Mn0.57]O2 cathode with optimal Li-substitution exhibits a reversible capacity of 168 mAh g-1 at 0.1 C rate and good cycling stability (82% retention after 100 cycles).5 In-situ XRD measurement reveals a complete solid-solution formation and X-ray absorption spectroscopy studies confirm the participation of Ni4+/Ni2+ and Mn4+/Mn3+ redox couples during Na+-extraction/insertion. Lastly, a full Na-ion cell with hard carbon is demonstrated with an energy density of 420 Wh kg-1. In subsequent work, a Li and Ti co-substitution strategy is applied to design a high-entropy O3-type NaLixNiyFezMn0.5Ti0.5-aO2 cathode.6 It retains 77% of its initial capacity after 400 cycles at a 2 C rate with a facile O3-P3-OP2-P3-O3 phase transition. The co-substitution strategy uplifts the average voltage of the system, improves the reversibility of the high-voltage OP2 phase, and enhances the Na-ion diffusion rate. A mere 1.32% unit cell volume change and diminishing electrochemical cell resistance over cycling ensure its superior long-term cycling performance. A full cell is fabricated, which holds 62% of its initial capacity even after 1000 cycles at a 0.5 C rate. Therefore, mono- and di-ion substitution strategies hold enormous potential for designing high-performing P2- and O3-type cathode materials for practical SIBs. References T. Hosaka, K. Kubota, A. S. Hameed, and S. Komaba, Chem. Rev., 120, 6358–6466 (2020).J. Y. Hwang, S. T. Myung, and Y. K. Sun, Chem. Soc. Rev., 46, 3529–3614 (2017).F. Zhang, J. Liao, L. Xu, W. Wu, and X. Wu, ACS Appl. Mater. Interfaces, 13, 40695–40704 (2021).Z. Lu and J. R. Dahn, J. Electrochem. Soc., 148, A1225 (2001).A. Ghosh, B. Senthilkumar, S. Ghosh, P. Amonpattaratkit, and P. Senguttuvan, J. Electrochem. Soc., 170, 030538 (2023).A. Ghosh, R. Hegde, and P. Senguttuvan, J. Mater. Chem. A., submitted(2023).