Abstract
A one-port surface acoustic wave (SAW) resonators incorporating Langmuir-Blodgett (LB) films has been investigated. SAW sensors are one potential applications of SAW devices. Most of the work reported on SAW sensor concerns delay lines. In this paper we characterize the mass loading effects of one-port resonators by depositing successive monolayers of LB films onto the surface. A 90 MHz SAW gas-phase sensor has been fabricated on an ST cut quartz substrate, and one-port resonator configurations have been used as the sensing element. Ultra thin monolayers of arachidic acid and arachidic acid ethyl ester have been deposited using the LB method. The resonant frequencies and the Q values have been measured as sensor response. Experimental results show that the Q values and the resonant frequencies of the one-port SAW resonator vary with film mass loading on the SAW device surface.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callSimilar Papers
More From: IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
