Abstract
Peroxide radical treatments of a perfluorinated ionomer used in polymer electrolyte membrane (PEM) fuel cells and its small molecule analogues were carried out, along with analysis of the resultant products. Molecules containing terminal carboxylic acids degraded at least 1 order of magnitude faster than noncarboxylate materials; all of the systems did show peroxide-initiated degradation nonetheless. Product analysis suggests that terminal carboxylic acids react according to a sequential chain shortening, consistent with previous studies. Cleavage of side chains from both polymer and model compounds was also observed to be important and in fact may be the dominate pathway in low carboxyl content commercial PEM membranes, based on the following comparison of reactivity and concentration. The relative reactivities of carboxylic chain ends and ether linkages is approximately 500, as calculated using model compounds fluoride generation rates. Commercial perfluorosulfonic acid (PFSA) products contain minimal carboxylic acid end groups, and the side chain concentrations are of 2−3 orders of magnitude higher than carboxylic acid end groups.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.