Abstract
This paper reports the results of the direct treatment of PCBs sorbed to solid particles (glass beads and sand) employing the Fenton process. The results obtained with contaminated sandy soils show 98% removal of the original PCB structure and 82% dechlorination, all within a reaction time of 72 hours. The degree of removal was observed to be dependent on the level of congener chlorination. The optimized conditions were: 5% H2O2; 100 ppm Fe3 +; sandy soil mass/volume of oxidizing solution ratio (m/V) of 1/3 g/mL, vigorous agitation and dispensed with the need for heat. Results obtained by applying an integrated desorption treatment followed by photo-Fenton oxidation to sandy soils contaminated with PCBs are also present in this paper. Desorption of PCBs with surfactant solutions took place to an extent of around 90% (92.2% with K-perfluoroalkyl sulfonate, FT800, and 87% with Lineal Alkyl benzene Sulfonate, LAS), while photo-Fenton oxidation at 254 nm achieved degradation percentages close to 100% in 30 minutes for PCBs in solution, both with FT800 (98%) and LAS (97%) surfactants.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Environmental Science and Health, Part A
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
