Chelation gradients for investigation of metal ion binding at silica surfaces.

Abstract

Centimeter-long surface gradients in bi- and tridentate chelating agents have been formed via controlled rate infusion, and the coordination of Cu(2+) and Zn(2+) to these surfaces has been examined as a function of distance by X-ray photoelectron spectroscopy (XPS). 3-(Trimethoxysilylpropyl)ethylenediamine and 3-(trimethoxysilylpropyl)diethylenetriamine were used as precursor silanes to form the chelation gradients. When the gradients were exposed to a metal ion solution, a series of coordination complexes formed along the length of the substrate. For both chelating agents at the three different concentrations studied, the amine content gradually increased from top to bottom as expected for a surface chemical gradient. While the Cu 2p peak area had nearly the same profile as nitrogen, the Zn 2p peak area did not and exhibited a plateau along much of the gradient. The normalized nitrogen-to-metal peak area ratio (N/M) was found to be highly dependent on the type of ligand, its surface concentration, and the type of metal ion. For Cu(2+), the N/M ratio ranged from 8 to 11 on the diamine gradient and was ∼4 on the triamine gradient, while for Zn(2+), the N/M ratio was 4-8 on diamine and 5-7 on triamine gradients. The extent of protonation of amine groups was higher for the diamine gradients, which could lead to an increased N/M ratio. Both 1:1 and 1:2 ligand/metal complexes along with dinuclear complexes are proposed to form, with their relative amounts dependent on the ligand, ligand density, and metal ion. Collectively, the methods and results described herein represent a new approach to study metal ion binding and coordination on surfaces, which is especially important to the extraction, preconcentration, and separation of metal ions.