Abstract
Since high density operation is advantageous for building an efficient fusion reactor, understanding the density limit in tokamaks has been seen as one of the most important issues. This paper reports a series of measurements around the last-closed flux surface (LCFS) in L-mode plasmas by using a thermal helium beam diagnostic. Fluctuation analysis has been employed to characterize the poloidal flow and the turbulence structure. A reversal of the poloidal flow in the scrape-off layer and concomitant cooling of the outer divertor plasma are observed as the density is raised. While, in the confined region, the change in the density barely affects the poloidal flow, a higher density shifts the fluctuation power spectral densities toward lower frequencies and wave numbers. The eddy tilting of this region is consistent with what is expected from the magnetic shear effect. A radially coherent low frequency mode appears in the case of the highest density investigated in this study (n¯e/ne,GW = 0.51), and higher frequencies near the LCFS are modulated by this mode.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.