Characterizing surface porosity of porous membranes via contact angle measurements

Abstract

This investigation attempts to establish and verify a novel method for quantifying surface porosity of porous polymeric membranes via contact angle measurements. Herein, we fabricate a series of porous membranes via nonsolvent induced phase separation (NIPS) comprising different concentrations of polyvinylidene fluoride (PVDF) and PVDF-poly (methyl methacrylate) block co-polymer (PVDF-PMMA) with different concentrations of water and isopropyl alcohol (IPA) in the coagulation bath. Both sessile drop and captive bubble contact angle measurements are used to determine contact angles (and porosity) for both dry and wet membranes, respectively. The former method is probably applicable for membrane distillation, aeration and de-aeration where liquid water does not saturate the membrane, whereas the latter may be more indicative of pressure-driven aqueous membrane separations where the membrane is saturated through its cross-section. Image analysis of scanning electron microscope (SEM) images quantified dry membrane surface porosity. We propose a simple analytical model to obtain wet and dry membrane surface porosity from contact angle measurements. Our results suggest that the surface porosity calculated from both wet and dry contact angle data correlates strongly with the surface porosity calculated from SEM values. However, wet contact angles of the membranes with high porosities produce significantly higher porosity values, which also establishes the importance of porous membrane swelling in determining membrane porosity for aqueous membrane separations.