Characterization of vehicular brake service personnel exposure to airborne asbestos and particulate.

Abstract

Evaluation of fibers and total particulate generated during the servicing of drum brakes on motor vehicles as well as during the resurfacing (arcing) of brake shoes was conducted. Conditions for the studies were based on review of contemporary (approximately 1950-1980) working practices in the industry. This work was conducted in two parts. Phase 1 estimated the release of asbestos fibers and total particulate during brake inspection and replacement of light-duty vehicle rear drum brakes at an auto/truck repair facility. Two distinct work practices were evaluated: One rear wheel from each vehicle was serviced using compressed air to remove dust while the second rear wheel was serviced without compressed air. Area and personal monitoring of fiber levels demonstrated counts (without compressed air) that ranged from 0.05 to 0.2 f/cc. Fiber counts when using compressed air averaged from 0.05 to 0.9 f/cc. Results from real-time aerosol monitoring indicated elevated dust levels for about 15 minutes after blow out. With shop doors open, dust levels increased to 5.0 mg/m3 at blow out and returned to 0.08 mg/m3 within two minutes. When the shop doors were closed, the dust levels reached 13.5 mg/m3 at blow out and decreased to 1.68 mg/m3 within one minute and to background within 14 minutes. The Phase 2 series evaluated the release of fibers and other particulate from are grinding. For operations conducted under conditions simulating a workplace, a mean of 0.19 f/cc +/- 0.16 was determined. Dust levels averaged 0.25 mg/m3 +/- 0.05. Brake service monitoring in these tests demonstrates that asbestos fiber concentrations, considered on a time weighted average basis, should not exceed currently acceptable workplace standards whether or not the worker uses compressed air, nor during the arc grinding process when arcing is conducted in accord with the design of the equipment.