Abstract

The purpose of this paper is to characterize, to compare different types of tunnel oxides and to determine the impact on the MB (Moving Bit measurement) issues. The measurements and comparison carried out for the following tunnel oxide thickness in the range of 8 to 10 nm is used. They are: (1) Dry oxidation at 900 C which gives acceptable oxide quality in the thickness range of 100 /spl Aring/ (2) 5% O/sub 2/ diluted oxidation at 900 C, (3) 5% O/sub 2/ diluted oxidation at 960 C and (4) Wet oxidation at 750 C which gives superior results even for a minimal oxide thickness of 88.9 /spl Aring/.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.