Characterization of Traveling-Wave Josephson Parametric Amplifiers at T = 0.3 K

Abstract

The growing interest in quantum technologies, from fundamental physics experiments to quantum computing, demands for extremely performing electronics only adding the minimum amount of noise admitted by quantum mechanics to the input signal (i.e., quantum-limited electronics). Superconducting microwave amplifiers, due to their dissipationless nature, exhibit outstanding performances in terms of noise (quantum limited), and gain. However, bandwidth and saturation power still show space for substantial improvement. Within the DARTWARS <xref ref-type="fn" rid="fn1" xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">¹</xref> <fn id="fn1" xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"><label>¹</label> DARTWARS (Detector Array Readout with Traveling Wave AmplifieRS), funded by Italian National Nuclear Institute (INFN), is a quantum technologies project targeted at the development of wideband superconducting amplifiers with noise at the quantum limit and the implementation of a quantum-limited readout in different types of superconducting detectors and qubit. </fn> collaboration, we are developing state-of-the-art microwave superconducting amplifiers based on Josephson junction arrays and on distributed kinetic inductance transmission lines. Here we report the realization of a setup for the characterization of the performances of Josephson traveling-wave parametric amplifiers at a temperature of 300 mK. Although in the final experimental setup, these amplifiers will operate at a base temperature of about 20 mK, their characterization at 300 mK allows to evidence the main aspects of their performances, but the ultimate noise level. This represents a quick and relatively inexpensive way to test these superconductive devices that can be of help to improve their design and fabrication.