Abstract
Amorphous carbon (a:C) films prepared on pure titanium (Ti) substrates exhibit relatively high intrinsic compressive stress. In order to obtain low stress films with varied electrical and mechanical properties, metal (Ti) ions are incorporated into the plasma. This is done with the help of metal containing carbon targets. Amorphous carbon films with varied percentage of Ti were deposited on polished pure Ti substrates using Filtered Cathodic Vacuum Arc (FCVA) technique together with substrate pulse biasing. Characterizations of the films were carried out using various equipments including Raman Spectroscopy, X-ray diffractometer, Atomic Force Microscopy (AFM), Pin-on-Disk Tribometer and Micro-Scratch Tester; and properties such as microstructure, crystallography, film stress, morphology, frictional coefficient and critical load were investigated as a function of Ti content in the target. The results suggest that the film prepared with 5 at.% Ti-containing carbon target, under 7 kV substrate pulse bias voltage, displays almost zero stress. However such films are inferior in its Tribological properties compared to that of pure a:C films.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
