Abstract
An anodic titanium oxide film containing Ca and P (AOFCP) was formed on commercially pure titanium which was anodized in an electrolytic solution of dissolved beta-glycerophosphate (beta-GP) and calcium acetate (CA). Hydroxyapatite (HA) crystals were precipitated by hydrothermally heating the AOFCP at 300 degrees C. After hydrothermal treatment, the film was characterized by scanning electron microscopy (SEM), energy-dispersive X-ray microanalysis (EDX), and tensile tests. The morphology, composition, and amount of HA crystals precipitated were significantly affected by the composition of the electrolytes. Near-stoichiometric HA crystals with high crystallinity were precipitated completely covering the AOFCP surface at specific electrolyte concentrations. The HA layers were thin at 1-2 microns in thickness. The adhesive strength of the film increased with decreasing electrolyte concentration and the maximum value was about 40 MPa. In vitro tests for 300 days suggested that the stability of the film was high. The high adhesive strength may result from the AOFCP existing as an intermediate layer between the HA layer and a titanium substrate. The intervention of the AOFCP may have prevented abrupt changes in Ca and P content at an HA coating-titanium interface as seen in a plasma-sprayed one. The porous TiO2 matrix of the AOFCP may be suitable for nucleation sites of HA crystals, as well as SiO2 matrix of silicate bioactive glasses or glass ceramics.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.