Characterization of ramie fiber/soy protein concentrate (SPC) resin interface

Abstract

Ramie fiber/soy protein concentrate (SPC) polymer (resin) interfacial shear strength (IFSS) was measured using the microbond technique. To characterize the effect of plasticization, SPC resin was mixed with glycerin. Fibers were also treated with ethylene plasma polymer to reduce fiber surface roughness and polar nature to control the IFSS. Fiber surfaces after ethylene plasma polymerization, and fracture surfaces of specimens before and after the microbond tests were characterized using a scanning electron microscope (SEM). Some specimens were also characterized using electron microprobe analyzer (EMPA) to map the residual resin on the fiber surface after the microbond test. Effects of glycerin concentration in SPC and ethylene plasma fiber surface treatment time on the IFSS were investigated. Preparation of SPC resin requires a large amount of water. As expected, during drying of SPC resin, the microdrops shrank significantly. The high IFSS values indicate strong interfacial interaction in the ramie fiber/SPC resin system. This strong interfacial interaction is a result of a highly polar nature of both the ramie fiber and the SPC resin and rough fiber surface. Ethylene plasma polymerization was used to control the IFSS. The plasma polymer imparted a polyethylene-like, non-polar polymer coating on the fiber surface. As a result, the fiber surface became smoother compared to the untreated fiber. Both fiber smoothness and non-polar nature of the coating reduced the ramie fiber/SPC resin IFSS. Plasticization of the SPC resin by glycerin also decreased the adhesion strength of the ramie fibers with the SPC resin. The load-displacement plots for IFSS tests obtained for different resin and fiber combinations indicate different interfacial failure modes.