Abstract

Partial Discharge (PD) detection is one of the important methods used to evaluate the insulation condition of in-service high voltage (HV) electrical equipment. On-site PD detection methods are preferred compared to other methods as non-intrusive sensors are easier to install and have no interruptions on the operation. An electrical PD testing utilizing High Frequency Current Transformer (HFCT) installed at the ground terminal of the in-service instrument transformer was used to detect partial discharge activities. However, the limitation of this method is the measurement often lacks of accuracy due to interference in the measured PD waveforms. Therefore, such PD signals are hard to be distinguished from the stochastic noise pulses. Hence, the characteristics of PD signals and interference signals are studied in the Phase Resolved Partial Discharge (PRPD) pattern in order to identify the extent of PD occurrence in the signals. The discharge magnitude could increase significantly because of the noise signals superposed with PD signals. Therefore a method that can remove high magnitude noise will be proposed by using statistical signal processing technique.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call