Abstract

The aim of this paper to quantitatively characterize the microstructure of tempered martensitic/bainitic Ni-Cr-Mo steels with different Ni contents. Though it is difficult to characterize the phase factions in the Ni-Cr-Mo low alloy steel due to the microstructural similarity of tempered lower bainite and tempered martensite, the phase fractions could determined with the as-quenched specimens by using three successive measurements of ferrite scope, scanning electron microscopy images and electron back-scattered diffraction. The martensite fraction is increased as the Ni content increases, and it causes the reduction effective grain size. When compare the boundary distributions of both as-quenched and tempered specimens, larger amounts of Σ11, Σ13, and Σ39 CSL boundaries were observed only in as-quenched model alloys. These boundaries were diminished by the tempering process. However, the peak of the Σ3 boundary was observed in both the as-quenched and tempered states. The frequency of Σ3 boundaries in the tempered samples is significantly increased as the Ni content increases, and it is closely related with the martensite fraction.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.